Nullam non lectus nec quam laoreet suscipit vel eget ligula. Aliquam condimentum venenatis luctus. Ut quis nibh nec tortor tempor faucibus sit amet ac metus. Nullam lacus nisi, lobortis et adipiscing eget, rutrum a eros. Duis a pharetra tortor. Nunc sollicitudin, turpis eget ultrices porttitor, mi est fermentum arcu, quis tristique quam leo a purus. Etiam bibendum lectus ac felis sollicitudin lobortis commodo ac ipsum. Fusce vitae augue dolor, ac accumsan diam.
Last 30 Posts
- MC350E Belt Cover and Face Plate Attachment (1)
- https://youtube.com/devicesupport
- Feed Dog Height 01
- Janome DC2014 – Feed Balance
- Janome DC2014 – Feed Dog Height
- Janome DC2014 – Front Cover Installation
- Janome DC2014 – Needle Position (Front-to-Back)
- Janome DC2014 – Needle Position (Left-to-Right)
- Janome DC2014 – Needle-to-Feed Timing
- Janome DC2014 – Removing the Covers
- Janome DC2014 – Removing the Front Cover and ‘A’ Board
- Janome DC2014 – Replacing the DC Motor
- Janome DC2014 – Replacing the Feed Step Motor
- Janome DC2014 – Replacing the Lower Shaft
- Janome DC2014 – Replacing the Presser Bar
- Janome DC2014 – Replacing the Socket Unit
- Janome DC2014 – Replacing the Transformer
- Janome DC2014 – Replacing the Zig Zag Motor
- 1110DX face,belt, base removal
- 1110DX knife adjustments
- 1110DX lower looper height
- 1110DX lower looper timing 7 clearance
- 1110DX needle bar height
- 1110DX preparation for service
- 1110DX top cover and front panel removed
- 1110DX upper looper clearance
- 1110DX upper looper drive arm position
- 1110DX upper looper position
- 1110DX upper looper timing
- TB12 adjusting the feed timing